The JZ forum


Join the forum, it's quick and easy

The JZ forum
The JZ forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.

1JZ-GTE Part reference list.

Go down

1JZ-GTE Part reference list.  Empty 1JZ-GTE Part reference list.

Post  Flicktitty Thu Dec 15, 2011 4:03 pm

Here are some things i have found that are interchangeable with the 1JZ-GTE, Please feel free to add other parts to the list.

Common parts between the 7M and 1JZ
- Clutch kits (but not flywheel)
- Cat back Exhausts
- 89+ motor mounts (rubber part)
- Anything trans (R154) related
- Anything gauge related
- Rad (if you're not using the 1J hydro fan setup)
- Driveshaft/Diff

Common parts between the 2JZ and 1JZ
- Power steering pump
- Alternator
- Spark plugs (ngk 3330 and 6097)
- US spec 550cc injectors (resistor pack needed)
- JDM Spec 440cc injectors (drop in upgrade)
- Water Pump (requires removal of the 1J hydro fan and a 2J pulley)
- Head gasket (although most other gaskets do not swap, get a 1J set to do it right)
- Clutch fan (if you use a MKIV water pump and pulley)
- Serpentine belt (but NOT timing belt - see below)
- Oil filter and relocation kits
- Intercooler kits
- Plug coils
- Cam gears (incl aftermarket adjustable)
- JDM 2JZ Map sensor
- Ignitor
(edit: some more added info)
1) The rod and main bearings.
2) The head bolts, crank and rod bolts from stock or ARP either bolts or studs w/nuts.
3) The pistons including the wrist pins, wrings and locks.
4) The head gasket, stock or aftermarket.
5) stock side feed or after market side feed high ohm injectors. Low ohm injectors require wiring in the 7M or preferably 2JZ injector resistor pack.
6) Water pump and housing when replacing the hydro fan to electric or clutch fan.
7) Cams are normally not interchangeable with out some grinding on the 2JZ cam and having it spun balanced, HKS, Jun and Blitz all make 256, 264, and 272 cams for the 1JZ.
Cool Cam shims, springs, retainers, Valves and springs, along with buckets are interchangeable.
9) turbos are not directly interchangeable and require a degree of machining to swap out the 12As for 12b.


The 1988+ Isuzu Trooper 4 cylinder 2.6 liter engine (4ZEL) uses the same belt as the Toyota 1JZ engine. So instead of getting a belt from Japan (~$100) you can pick up an Isuzu Trooper belt locally at an auto parts store for about $30 US. Make Sure You Get The 4 Cylinder 2.6 Litre Engine Belt!
Flicktitty
Flicktitty
Admin

Posts : 23
Join date : 2011-12-15
Location : Wi

https://thejzforums.board-directory.net

Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum